top of page

Home  /  Products  /  Tempering Furnace

Tempering Furnace

Forced-air batch or conveyor furnace for tempering hardened steel parts at 150–650°C.

Also called a tempering oven or tempering bhatti.

Key Features

  • Forced air for even tempering

  • Batch or continuous designs

  • Water-cooled fan bearings on hotter units

  • Soak timer with end-of-cycle alarm

  • Pairs with our hardening furnace

  • Gas or electric heating

Specifications

Working range: 150–650°C

Types: batch box/trolley or continuous mesh-belt conveyor

Airflow: forced air, SS-304/SS-310 fans

Conveyor drive: 1 HP AC variable speed (conveyor models)

Heating: electric or LPG/PNG/CNG burners

Insulation: up to 225 mm ceramic fibre + mineral wool

Controls: digital PID, soak timer, independent over-temperature controller

Options: recorder, paired hardening line

Industries: Steel forging and casting, fasteners, tools, auto parts

About the Tempering Furnace

Hardened steel is strong but brittle. Tempering reheats it to a lower temperature, from about 150°C for tools that must stay very hard to about 650°C for tough structural parts. It is held long enough for the whole section to soak, and the result is the hardness and toughness the drawing calls for. Tempering runs at temperatures where radiant heat alone is uneven. A tempering furnace therefore relies on forced air circulation to bring every part in the load to the same temperature.

 

AHS tempering furnaces are built as batch box or trolley furnaces and as continuous mesh-belt furnaces with forced air. The conveyor type is usually paired with a hardening furnace for nuts, bolts and small parts. Electric tempering ovens have been supplied to engineering units, and gas-fired conveyor tempering furnaces use a 1 HP AC variable-speed drive with 225 mm ceramic and mineral wool insulation. Circulation fans are SS-304 or SS-310, with water-cooled bearing housings on hotter units. Heating is electric, LPG, PNG or CNG, and control is digital PID with an independent over-temperature controller and a soak timer.

 

This page covers box, trolley and conveyor tempering furnaces. For long shafts, rolls and parts that are best hung vertically, see also our Tempering Pit Furnace. For hardening ahead of tempering, see the Hardening Furnace. For springs, see the Spring Stress Relieving Oven. Tell us the parts, weight per hour or per batch, and the tempering temperature you need, and we will recommend batch or conveyor.

 

Typical applications

  • Tempering hardened fasteners

  • Tempering tools, dies and punches

  • Tempering gears and shafts

  • Tempering springs and clips

  • Tempering forgings after hardening

 

Common questions

What temperature is used for tempering?

From about 150°C to 650°C. Lower temperatures keep more hardness, and higher ones give more toughness.

 

Why does a tempering furnace need forced air?

At tempering temperatures, radiant heat alone is uneven. Fans bring every part to the same temperature.

 

What is the difference from a tempering pit furnace?

This furnace is box, trolley or conveyor type. The Tempering Pit Furnace hangs long parts vertically.

 

Can it be paired with a hardening conveyor?

Yes. We build matched hardening and tempering conveyor lines.

 

How long should parts be tempered?

At least until the whole section reaches temperature, then as per your heat treatment specification.

 

Related ovens and furnaces

 

Need a quotation? Share your load size, working temperature and fuel, and we will suggest a design. Call +91 98105 20120, message us on WhatsApp or send an enquiry. For a quick figure first, try our oven heat load calculator.

bottom of page