Home / Wire & Spring Industry
Ovens for Wire, Mesh and Spring Makers
Stress relieving ovens for springs and wire forms, annealing furnaces for drawn wire and curing ovens for coated mesh, in batch or continuous designs sized to your output.
Equipment for Wire, Mesh and Spring Units
Relieves coiling stress in springs and wire forms so they hold their load in service.
Softens drawn wire in coils or on spools so it can be drawn or formed further.
Anneals stacked coils under a sealed cover and protective atmosphere for a bright finish.
Continuous oven for small springs, clips and fasteners, with belt speed set to the soak time.
Tempers springs and wire parts after hardening, with air circulation for even hardness.
Cures powder on welded mesh, fencing panels and wire products, in batch or conveyor form.
Typical stress relieving and annealing cycles
Music wire and hard-drawn carbon steel springs: about 230°C to 290°C for 20 to 30 minutes.
Oil-tempered and chrome-silicon springs: about 260°C to 425°C for 30 to 60 minutes.
Stainless steel springs: about 350°C to 430°C for around 30 minutes.
Low-carbon steel wire annealing: 650°C to 720°C, under a protective atmosphere where a bright surface is needed.
Copper and brass wire: typically 400°C to 650°C, depending on the alloy and temper.
These are general industry figures; the wire grade and diameter set the actual cycle. Time counts from when the springs reach temperature, so a dense basket load needs longer than a single layer on a belt.
