top of page

Home  /  Products  /  Gas Fired Rotary Dryer

Gas Fired Rotary Dryer

Rotating drum dryer heated by LPG/PNG burners for powders, granules and chemicals.

Also called a rotary drum dryer, gas heated rotary dryer or rotary dryer machine.

Key Features

  • Continuous drying of powders and granules

  • Variable feed rate and drum speed

  • Automatic gas burner with flame safety

  • Stainless steel drum for clean product

  • Overshoot protection

  • Single or multi-zone heating

Specifications

Drum: 3 mm SS-304 or SS-310 (to duty)

Heating: automatic LPG/PNG burner, e.g. 2,00,000 kcal/hr

Zones: 1 to 3 burners and fans

Working temperature: ambient to 100°C typical; higher on request

Feeding: hopper with screw conveyor on VFD

Discharge: chute

Insulation: 75 mm rock fibre to 150 mm ceramic fibre and rock wool

Drives: AC drives for drum and feeder

Safety: overshoot safety controller, flame safety

Industries: Chemicals, metal recycling, minerals

About the Gas Fired Rotary Dryer

A rotary dryer is a long drum, slightly inclined, that turns slowly while wet material travels from the feed end to the discharge end. Flights inside the drum lift the material and let it fall through the hot air, so every particle is exposed and drying is even.

 

AHS rotary dryers are heated by automatic LPG or PNG burners. In one AHS design for zinc material, a 2,00,000 kcal/hr LPG burner heats a 3 mm SS-304 drum, the material is fed from a hopper by a screw conveyor on a variable-frequency drive, and the dried product leaves through a chute. That dryer runs from ambient to 100°C, with a 150°C maximum and a safety controller against overshoot, 75 mm rock-fibre insulation and AC drives for the drum and feeder.

 

For higher duty, AHS has designed a 3-zone dryer with three burners firing in SS-310, a 3 mm SS-310 drum, three fans and 150 mm ceramic fibre and rock wool insulation.

 

Drum size, burner rating and rotation speed are worked out from your material, moisture in and out, and output per hour. AHS has invoiced gas heated rotary dryers to chemical and recycling companies.

 

Typical applications

  • Zinc and metal compounds

  • Chemical powders and salts

  • Recycled materials

  • Minerals and fillers

  • Sand and granules

  • Pre-drying before calcining

 

Common questions

What size dryer do I need?

It depends on output in kg per hour, moisture before and after drying, and how the material behaves. Send us these details and a sample description.

 

LPG or PNG?

Both work with the same burner type. PNG is usually cheaper and avoids cylinder handling if a pipeline is available.

 

Does the flame touch the material?

The arrangement depends on the product. We advise direct or indirect heating after knowing whether your material can contact combustion gases.

 

Is the drum stainless steel?

Yes. AHS uses SS-304 or SS-310 drums depending on temperature and material.

 

Do you supply dust collection?

Dust collection depends on the material and local norms. We can include a cyclone or integrate with your existing system on request.

 

Related ovens and furnaces

 

Need a quotation? Share your load size, working temperature and fuel, and we will suggest a design. Call +91 98105 20120, message us on WhatsApp or send an enquiry. For a quick figure first, try our oven heat load calculator.

bottom of page