top of page

Home  /  Products  /  Lead Melting Pot Furnace

Lead Melting Pot Furnace

Gas fired or electric furnace that heats a lead pot for melting, casting and Barton feed.

Also called a lead melting furnace, lead pot furnace, lead melting kettle or lead refining pot; known locally as a lead galane ki bhatti.

Key Features

  • Steady heat around the pot

  • Sloped bottom and drain chute for leak safety

  • Gas or electric heating

  • Compact furnace body

  • Built to your pot size

  • Spares and burner service available

Specifications

Example pot: 550 mm diameter × 485 mm deep (customer scope)

Furnace body: 1,100 mm diameter × 800 mm high

Plates: 12 mm top, 5 mm bottom and sides

Operating temperature: 400°C

Heating: 1 gas burner (LPG/PNG); electric on request

Insulation: 100 mm ceramic fibre and mineral wool; 50 mm sloped castable bottom

Leak drain: 150 × 150 mm chute

Chimney: 100 mm, insulated

Control: burner control and temperature controller

Industries: Lead-acid batteries, lead oxide, lead products

About the Lead Melting Pot Furnace

Lead melts at about 327°C, so a lead melting furnace does not need very high temperature. It needs steady, even heat around the pot, good insulation and safe handling of hot metal. Lead pots feed Barton oxide plants, grid casting machines and alloying work in battery plants.

 

An AHS Barton melting furnace for a lead oxide plant takes a pot of 550 mm diameter and 485 mm depth, in a furnace body of 1,100 mm diameter and 800 mm height. The top plate is 12 mm and the bottom and sides 5 mm, with steel support ribs. It runs at 400°C on one gas burner, with 100 mm ceramic fibre (128 density) and 150 kg/m³ mineral wool on the side wall and 50 mm sloped refractory castable at the bottom. A 150 × 150 mm drain chute takes molten lead away safely if the pot leaks.

 

A 100 mm insulated chimney removes flue gas, and the panel carries burner control, a temperature controller and protection MCB. Larger pots and electric heating can be made to suit your melt rate.

 

AHS has invoiced lead melting and Barton melting furnaces to a lead oxide plant. AHS also designed rotary lead melting furnaces in earlier years. The pot itself is normally supplied by the customer.

 

Typical applications

  • Melting lead for Barton oxide plants

  • Lead for battery grid and part casting

  • Lead alloying

  • Lead for cable sheathing and sheet

  • Small lead casting units

 

Common questions

What temperature does a lead pot need?

Lead melts at about 327°C. AHS lead melting furnaces run at about 400°C to keep the metal fluid.

 

Do you supply the pot?

Usually the pot is supplied by the customer. AHS builds the furnace body, insulation, burner and controls to fit it.

 

Gas or electric?

Gas burners are standard. Electric heaters around the pot can be supplied where gas is not available.

 

What if the pot leaks?

A drain chute and sloped bottom carry molten lead away from the insulation and burner.

 

How large a pot can you heat?

Pot size is made to your melt rate. Tell us the kg per hour and pot size you plan to use.

 

Related ovens and furnaces

 

Need a quotation? Share your load size, working temperature and fuel, and we will suggest a design. Call +91 98105 20120, message us on WhatsApp or send an enquiry. For a quick figure first, try our oven heat load calculator.

bottom of page