Industrial CNG Burner
Automatic burners and gas trains for ovens and furnaces running on compressed natural gas (CNG).
Also called a CNG gas burner, natural gas burner for furnace or CNG bhatti burner.



Key Features
Burner management matched to CNG supply
Double safety shut-off valves
Flame-failure lockout and alarm
High/low flame on larger burners
Easy later switch to PNG
Fitted to AHS and other makes of equipment
Specifications
Fuel: CNG (compressed natural gas) after site pressure reduction
Types: self-proportional and mono-block
Capacity: sized to heat load in kcal/hr
Sequence: pre-purge, auto ignition, flame supervision, lockout on flame failure
Flame control: on/off or high/low on bigger burners
Gas train: filter, regulator, double solenoid valves, pressure switches
Controls: burner sequence controller with alarm
Migration: re-tuning to PNG when pipeline supply arrives
Industries: Aluminium, welding electrodes, powder coating, heat treatment
About the Industrial CNG Burner
Not every factory has a PNG pipeline at the gate. Many units buy natural gas as CNG, delivered in cylinder cascades and let down to burner pressure on site. CNG burns like PNG, because it is the same gas, but the supply side is different. Gas arrives at very high pressure and must be reduced in stages, filtered and regulated before it reaches the burner. Supply also depends on cascade changeovers. A CNG burner system has to handle all of this safely and keep the oven running steadily.
AHS supplies automatic burners for CNG supply with the same burner management as our LPG and PNG burners. Each system has pre-purge, automatic ignition, flame supervision and lockout with an alarm on flame failure, plus high and low flame on bigger burners. The gas train is matched to the pressure supplied by your pressure-reduction system, with filter, regulator, double solenoid safety valves and pressure switches. Burners are sized in kcal/hr to the heat load. Because CNG and PNG are the same fuel, a burner set up for CNG can usually move to PNG later with re-tuning, once a pipeline reaches your area.
AHS fits CNG burners to annealing ovens, electrode baking ovens, curing ovens, hot air generators and melting furnaces. We also convert oil-fired equipment to natural gas. For LPG, PNG and dual-fuel burners, and for oil-to-gas conversions, see also our Industrial Gas Burner page. Tell us your equipment, heat load and the outlet pressure of your CNG pressure-reduction skid, and we will size the burner and gas train.
Typical applications
Firing annealing ovens on CNG supply
Heating electrode baking ovens
Firing curing and powder coating ovens
Firing hot air generators and dryers
Firing melting furnaces at sites without PNG
Common questions
Is a CNG burner different from a PNG burner?
The gas is the same natural gas. The difference is the supply side. CNG must be reduced from high pressure and regulated before the burner.
Can I move to PNG later?
Yes. A CNG burner can usually be re-tuned for PNG when a pipeline reaches your area.
What safety features are included?
Pre-purge, automatic ignition, flame supervision, lockout on flame failure, double solenoid valves and pressure switches.
Do you supply the pressure-reduction skid?
The skid is normally part of your CNG supply arrangement. We match the burner gas train to its outlet pressure.
Can you convert my oil-fired furnace to CNG?
Yes. See our Industrial Gas Burner page for conversions.
Related ovens and furnaces
Need a quotation? Share your load size, working temperature and fuel, and we will suggest a design. Call +91 98105 20120, message us on WhatsApp or send an enquiry. For a quick figure first, try our oven heat load calculator.
