top of page

Home  /  Products  /  Truck-in Oven

Truck-in Oven

Batch oven with a floor-level opening so loaded trucks, carts or pallets are pushed straight in.

Key Features

  • Floor-level entry with no ramp or sill to cross

  • Reinforced floor plate rated for the loaded truck weight

  • Guide rails to position each truck in the air stream

  • Adjustable supply louvres to balance top and bottom shelves

  • Single or multi-truck chambers with front or both-end doors

Specifications

Temperature: Up to 300°C (higher on request)

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Batch & Walk-in Ovens

Industries: Automotive, coating, rubber, composites

 

A truck-in oven has its floor level with the shop floor, so a loaded truck, cart or pallet truck rolls straight in without a ramp. The floor is reinforced to carry the wheel loads and the insulation sits below it. It suits heavy batches that change often, where lifting each load onto oven shelves would waste time. Typical working range is 80°C to 250°C for curing, drying and post-curing. The design starts from the truck: its footprint, loaded weight and wheel type decide the floor construction and door opening. Airflow is normally horizontal across the truck, with adjustable louvres so that the top and bottom shelves see the same temperature.

bottom of page