top of page

Home  /  Products  /  Thermoforming Preheating Oven

Thermoforming Preheating Oven

Oven for heating plastic sheets until soft enough to form.

Key Features

  • Even heating across the full sheet

  • Hot-air heating for thick sheets

  • Sheets hung or clamped to prevent sag marks

  • Pre-drying mode for moisture-absorbing plastics

  • Fast, wide-opening doors for quick transfer

Specifications

Temperature: Up to 200°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Rubber, Plastic & Composite Ovens

Industries: Plastic forming, signage

 

Before a plastic sheet can be vacuum formed or bent, it has to be heated until it is soft and pliable through its whole thickness. A thermoforming preheating oven does this evenly, so the sheet stretches uniformly and the formed part has consistent wall thickness. Forming temperatures are typically 140°C to 190°C depending on the plastic. Thick sheets are heated in hot air so the core warms without scorching the surface. Some plastics absorb moisture and must be pre-dried at a lower temperature first, or they will bubble when heated.

bottom of page