top of page

Home  /  Products  /  Solder Mask Curing Oven

Solder Mask Curing Oven

Oven for curing solder mask and legend inks on circuit boards.

Key Features

  • Even temperature across large panels

  • Filtered air for a clean coating

  • Tack-dry and final-cure programs

  • Rack, trolley or conveyor handling

  • Exhaust for solvent vapour

Specifications

Temperature: Up to 180°C

Heating: Electric or gas (indirect firing)

Category: Electrical & Electronics Ovens

Industries: PCB manufacturers

 

Solder mask is the coating that protects a circuit board and defines where solder can go. After it is applied, it is dried to a tack-free state for imaging and later given a final cure that makes it hard and resistant to heat and chemicals. Legend ink is cured the same way. Tack drying is typically done at about 75°C to 80°C and the final cure at about 150°C for up to an hour. Even temperature across the panel prevents patches of under-cure. Filtered air keeps dust off the wet surface. The oven is built to 180°C as a batch unit or conveyor tunnel.

bottom of page