top of page

Home  /  Products  /  Primer and E-coat Curing Oven

Primer and E-coat Curing Oven

Oven for curing primers and electro-deposition (ED) coatings on vehicle bodies and metal parts.

Key Features

  • Heat-up zone followed by controlled hold zones

  • Airflow directed into cavities and box sections

  • Drip and drain area ahead of the oven

  • Exhaust for cure vapours with fresh air make-up

  • Zoned control for mixed heavy and light sections

Specifications

Temperature: Up to 220°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Coating & Paint Curing Ovens

Industries: Automotive, ancillaries, appliances

 

This oven cures electro-deposited primer and spray primers on vehicle bodies, chassis parts and metal components. Electrocoat needs the metal held at roughly 160°C to 180°C for 20 to 30 minutes to cross-link fully. Boxed sections and inner cavities must reach that temperature too, not only the outer skin. Parts arrive wet from the rinse stages, so the first zone drives off water before the cure zones take over. Airflow is aimed into openings and along sills, and the oven is zoned so heavy and light areas of the same part finish together. Exhaust removes the vapours released during cure.

bottom of page