top of page

Home  /  Products  /  Plastic Annealing Oven

Plastic Annealing Oven

Oven for relieving stress in moulded and machined plastic parts.

Key Features

  • Programmable heat, hold and slow cool

  • Even temperature to avoid warping

  • Flat shelves and supports for sheets and rods

  • Gentle airflow that does not disturb light parts

  • Accurate low-temperature control

Specifications

Temperature: Up to 200°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Rubber, Plastic & Composite Ovens

Industries: Plastic moulders

 

Moulding and machining leave stress in plastic parts, which shows up later as cracking, crazing or warping. A plastic annealing oven heats the parts to a temperature just below their softening point, holds them, and cools them slowly so the stress relaxes. Settings depend on the material: roughly 80°C for acrylic, 120°C to 130°C for polycarbonate, about 150°C for nylon and around 200°C for high-performance plastics. Slow, controlled cooling is as important as the hold. The oven is built to 200°C with programmable ramps.

bottom of page