top of page

Home  /  Products  /  FRP Curing Oven

FRP Curing Oven

Oven for curing fibreglass reinforced plastic parts and moulds.

Key Features

  • Room-sized chambers for large mouldings

  • Gradual ramp to prevent distortion

  • Even airflow over long or tall parts

  • Trolley, rail or floor-level loading

  • Styrene fume exhaust

Specifications

Temperature: Up to 200°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Rubber, Plastic & Composite Ovens

Industries: FRP fabricators

 

Fibreglass parts made with polyester, vinyl ester or epoxy resin harden at room temperature but reach their full strength, heat resistance and chemical resistance only after a post-cure. An FRP curing oven provides that controlled heat for parts and moulds of almost any size. Post-cure is usually carried out at 60°C to 120°C for a few hours, following the resin supplier's schedule, and the oven is built to 200°C. Large tanks, pipes and panels need room-sized chambers with even airflow, and heating is raised gradually so the laminate does not distort.

bottom of page