top of page

Home  /  Products  /  Core Wash Drying Oven

Core Wash Drying Oven

Oven that dries the refractory coating (wash) applied to sand cores.

Key Features

  • High air velocity for fast surface drying

  • Conveyor flow from dip station to mould line

  • Temperature held low enough to protect the binder

  • Humid air exhausted continuously

  • Supports that do not mark the coated surface

Specifications

Temperature: Up to 200°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Foundry & Welding Ovens

Industries: Foundries

 

Cores are dipped or sprayed with a refractory wash that gives the casting a smooth surface. Water-based washes must be dried before the core is used. A core wash drying oven does this in minutes, where drying in open air would take many hours. Drying uses fast-moving air at roughly 100°C to 200°C, often on a conveyor so cores flow from dipping to the mould line. The aim is to dry the coating and the sand just beneath it without overheating the core, since too much heat weakens resin binders.

bottom of page