top of page

Home  /  Products  /  Copper and Brass Annealing Oven

Copper and Brass Annealing Oven

Oven for softening copper and brass parts, strips and coils between forming steps.

Key Features

  • Accurate control for consistent grain size

  • Optional protective atmosphere for a bright finish

  • Even heating of strips, coils and pressed parts

  • Cooling under cover to limit tarnish

  • Batch or continuous layouts

Specifications

Temperature: Up to 650°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Heat Treatment Ovens

Industries: Copper, brass, electrical parts

 

Copper and brass harden quickly when pressed, drawn or rolled. Annealing softens them between operations and gives finished parts the temper customers specify. Copper softens over a wide range, about 260°C to 650°C, while brass is usually annealed between 425°C and 600°C. Brass parts that will not be fully softened are often stress-relieved at about 250°C to 300°C to prevent cracking in service. Both metals tarnish in air when hot, so ovens for bright work use a sealed chamber with protective gas. Grain size, and therefore temperature accuracy, matters when parts will be deep drawn.

bottom of page