top of page

Home  /  Products  /  Brake Pad Curing Oven

Brake Pad Curing Oven

Oven for curing the resin in brake pads, brake shoes and clutch facings.

Key Features

  • Programmed step cycles over long periods

  • Strong, even airflow through stacked racks

  • Fume exhaust throughout the cycle

  • Racks and spacers for pads and linings

  • Batch record for each load

Specifications

Temperature: Up to 300°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Rubber, Plastic & Composite Ovens

Industries: Friction material makers

 

Brake pads, linings and clutch facings are bound with resin that is only partly cured in the press. A brake pad curing oven completes the cure over several hours, giving the friction material its final hardness, stability and resistance to heat. The cycle is stepped, typically rising between about 150°C and 230°C over four to twelve hours, so gases escape without blistering or cracking the pads. Fumes are exhausted throughout. Pads are stacked on racks with spacers so air passes between them, and the oven is built to 300°C.

bottom of page