top of page

Home  /  Products  /  Adhesive Curing Oven

Adhesive Curing Oven

Oven for curing structural adhesives and bonded assemblies.

Key Features

  • Sized for parts held in clamps or fixtures

  • Uniform heat so every joint cures alike

  • Ramp control for assemblies of mixed thickness

  • Chart or data record of each cure

  • Exhaust for adhesive fumes

Specifications

Temperature: Up to 250°C

Heating: Electric, gas (LPG/PNG/CNG) or furnace oil, or dual fuel

Category: Coating & Paint Curing Ovens

Industries: Automotive, electrical, composites

 

Heat-cured adhesives only reach their rated strength after a set time at a set temperature. An adhesive curing oven holds bonded assemblies at that schedule, commonly 120°C to 180°C for 20 to 60 minutes for structural epoxies, so every joint leaves with the same strength. The parts are normally clamped or held in fixtures while they cure, so the oven is designed around the loaded fixture, not the bare part. The glue line deep inside the joint must reach temperature, which takes longer than the surface, and a recorder can prove the cycle for quality records.

bottom of page